SGM3140B
SGM3140B is 500mA Buck/Boost Charge Pump LED Driver manufactured by SG Micro.
DESCRIPTION
The SGM3140B is a current-regulated charge pump ideal for powering high brightness LEDs for camera flash applications. The charge pump can be set to regulate two current levels for Flash and Torch modes.
The SGM3140B automatically switches modes between step-up and step-down ensuring that LED current does not depend on the forward voltage. It switches at 2.2MHz, allowing the use of tiny ponents. The supply voltage ranges from 2.7V to 5.5V and is ideally suited for all applications powered by a single Li-ion battery cell or three to four Ni Cd, Ni MH, or Alkaline battery cells.
The SGM3140B also features a very low shutdown current, an automatic soft-start mode to limit inrush current, as well as over-current, over-voltage and over-temperature thermal shutdown control.
A low current-sense reference voltage (47m V) allows the use of small 0603 current sensing resistors.
The SGM3140B is available in Green TDFN-3×3-10L package and is specified over an ambient temperature range of -40℃ to +85℃.
APPLICATIONS
White LED Torch, Flash for Cell Phones, DSCs and Camcorders White LED Backlighting Generic Lighting, Flash and Strobe Applications General Purpose High Current Boost
FEATURES
- Output Current Up to 500m A
- Up to 90% Efficiency in Torch Mode
- Adjustable Flash Mode Current
- Automatic Buck/Boost Mode Switchover
- Input Voltage Range: 2.7V to 5.5V
- Minimum External ponents: No Inductors
- High Frequency Operation: 2.2MHz
- Low 47m V Reference for Low Loss Sensing
- IQ < 1μA in Shutdown
- Automatic Soft-Start Limits Inrush Current
- Low Input and Output Ripple and Low EMI
- Output Over-Voltage Protection
- Over-Current and Over-Temperature Protection
- Available in Green TDFN-3×3-10L Package
TYPICAL APPLICATION
VIN 2.7V to 5.5V
CIN 4.7μF
CF 1μF
TORCH/FLASH ENABLE
1 VIN
VOUT 10
2 C1
9 PGND
3 C2
8 SGND
4 FLASH
7 FB
COUT 1μF
5 EN
6 RSET
RSET...
